Description
PTFE DRY LUBRICANT SPRAY
Dry lubrication, does not attract dirt and dust
Chemical basis: Polytetrafluoroethylene
Colour: Milky-transparent (protective film)
Density: 0.6 g/cm³
Smell/fragrance: Characteristic
Min. temperature conditions: -180 °C
Max. temperature conditions: 260 °C
Boiling point: -44 °C
VOC concentration (CH): 588.66 g/l
Silicone-free: Yes
Acid-free: Yes
Resin-free: Yes
Mineral oil-free: Yes
AOX-free: Yes
Contents: 300 ml
Container: Aerosol can
Remedies squeaking, creaking and jamming
Provides long-term protection against wear
10 µm film thickness
Can also be used with extremely small tolerances in precision engineering
Very high resistance
Temperature resistant from -180 °C to +260 °C (temporarily)
Permanently resistant to water, acids and bases
Mineral oil-free
Silicone-free
Notice
Smokers must wash their hands after use. Smoking contaminated tobacco products may cause health-related issues.
The usage instructions are recommendations based on the tests we have conducted and our experience. Carry out your own tests before each application. Due to the large number of applications as well as storage and usage conditions, we do not assume any liability for a specific application result. Any technical information or advice provided by our free customer service shall be provided to the exclusion of any liability, unless the advice or information is part of our contractually agreed scope of services or the advisor was acting wilfully. We ensure the consistent quality of our products. We reserve the right to make technical changes and further developments to our products.
Transparent, dirt-resistant dry lubricant for light to medium loads.
Suitable for dry lubrication of friction points. Can be used for metals, plastic, rubber etc. under low and medium loads. Ideal for sliding roof and seat rails, door hinges and locks, sliding doors, window tilt mechanisms, window locks, furniture hinges, drawers, guide rails, ball bearings, electrical switches etc. Also suitable as a release agent if applied economically.
Shake briefly before use. Spray a thin layer onto friction points or joints and allow to dry, drying time for a thin application: approx. 1-2 mins, drying time for a thicker application: approx. 5 mins.
*By request/order.